RHINO RC456 Návod k obsluze stáhnout pdf (Strana 18)

USING LEFT AND RIGHT-HAND MODELS

TO MAKE A V-RAKE

1. Install the Tool Bar Frame (1) to the tractor 3-point linkage using a forklift or crane. Raise the frame with tractor's

hydraulics. (See Illustration 13).

2. Install the 3-Point Upper and Lower Linkage (9 & 11) on the frame. Do not tighten bolts until all components are in

place and rakes are installed so minor adjustments can be made.

3. Install the assembled left and right rakes to the toolbar frame.

The working width of the V-Rake and the width of the windrow can be changed by moving the 3-Point Upper and Lower

Linkage (9 & 11) horizontally on the tool bar frame.

V-Rake in Operation

Illustration 13

Location for SMV Sign

Illustration 14

IMPORTANT: Safety reflectors have bee installed on the ends of the Tool Bar Frame to warn approaching traffic of a

potential hazard. Make sure reflectors are clean and in good condition at all times. Replace damaged or missing

reflectors immediately.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Žádné komentáře

RHINO RC456 Návod k obsluze Strana 18